AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Pfsense router10/13/2023 ![]() ![]() The bottom line is, the ideas apply anyway. The test / showcase was done with OPNsense here but I don't suppose it differs a lot from pfSense. But certainly the process to set that up is most likely troublesome. (Well, I mean the router part of Router certainly the switch part of it is always involved.) Other than configuring that manually on every host, replacing the DHCP server on Router with a more customizable one that allows you to configure additional route(s) to push is another option.įor example, you can configure pfSense to host a WAN-side DHCP server (I assume it is capable of what I just mentioned). You must additionally disable "Block private networks" if you chose to add an exception/pass rule only:įor the record, ideally speaking it would be best to have the route 192.168.77.0/24 via 192.168.0.254 configured on the 192.168.0.0/24 hosts, so that the communication in concern will be symmetric and not involving Router at all. Note that because the WAN side subnet in your case is a private one. The defaults are admin/pfsense, respectively. Enter your username and password in the login page. Which would also disable outbound NAT (so the first step can be skipped if you opt for this) To access the pfSense webconfigurator, open a web browser on a computer connected to your firewall and enter your LAN IP address. You can either simply disable the firewall entirely: Both manual and disable should work:īut apart from that, you will also need to configure the firewall for a bit. ![]() As mentioned in my comment, you will need to disable outbound NAT, otherwise the replies from backup drives won't be recognized as replies by MediaServer as their source IP address will become 192.168.0.254, which differs from the original traffics' destination address 192.168.77.10 (because destination NAT a.k.a.
0 Comments
Read More
Leave a Reply. |